Fitting An Ie Fc Cable 4 X 2 With An Ie Fc Rj-45 Plug 180 4X2 - Siemens 6GK1 901-1GB01 System Manual

14. Push the cable into position as
shown in the picture.
Make sure that the wires remain in
the guide slits and close the cover.
Notes: Make sure that the shield sits
correctly as shown in the picture above.
The visible color marking is not valid for
this type of installation.
2.3.5

Fitting an IE FC cable 4 x 2 with an IE FC RJ-45 plug 180 4x2

Introduction
The individual steps required to assemble a 8-wire IE FC cable and an IE RJ-45 plug 180
4x2 are explained below.
Refer to the information in this section "Industrial Ethernet FastConnect stripping tool
(Page 8)" and the installation instructions for the plug.
Note
Instructions for assembly
 The insulation-piercing contacts of the IE FC RJ-45 plug 4x2 can be released and
 Once the ends of cables have made contact, do not make contact with them again but cut
 Do not pull on the plug when releasing it.
 To assemble a cable with crossed over wires, connect the color-coded wires at one end
Passive network components
System Manual, 02/2013, C79000-G8976-C282-01
15. Turn the locking mechanism with
your hand as far as possible in the
direction of the arrow.
16. Insert a screwdriver (3mm) into the
slit in the locking mechanism and
turn it as far as the limit stop.
17. The connector is correctly locked
when the opening of the locking
mechanism is at the side and the
side edges are flush with the
connector.
recontacted with the same cable cross section up to 10 times.
them off.
of the cable in the connector as shown below:
– Connect orange-white with green-white
– Connect orange with green
– Connect brown-white with blue
– Connect brown with blue-white
Instructions for fitting connectors, attachments and devices
2.3 Electrical networks
Removal from an RJ-45 jack
1. If space is limited, release the plug
using a screwdriver (blade 3mm
wide).
Notice: When releasing, do not pull on
the plug!
21