Outputs; Indicator Panel Control Facility Spf 3200; Control Module Spf 5100 - Siemens SIGMASYS C Manual

A freely programmable 16-character text is displayed in the second line.
A key-operated s
can be used and
Eight zone operating pan
32 zone operating panels can be installed per SIGMASYS M control and
8.3

Outputs

8.3.1

Indicator panel control facility SPF 3200

64 freely programmable outputs for controlling site plan indicator panels or non-monitored un-
critical control fa
N.B.:
Indicator panel outputs can be deleted in the
sequently, these outputs should only be used for uncritical control facilities. Output current per
output is approx. 8 mA.
No series resistor is req
Bright LEDs with a power consumption of between 5 and 10 mA should preferably be used.
Two entries are available in SPF 3200 for disabling the acoustic signal and for the "Lamp test
function.
The indicator panel control facility occupies on
trol facility is supplied as a PCB for installation in boards or housing to be installed on the
building side.
A metallic housing should be used to avoid unwanted interference.
The indica tor panel control facility requires a power supply unit
Connection
A maximum of 6 connection cables are available for each of the ten (eleven) LED connec-
tions for the indicator panel control facility.
Ten-LED connection line C24217-A26-B2 as standard flat cable
connector at one end.
Six Opto cont
dicator panel control module.
Opto control module:
Maximum contact load:
Programmable control pattern:
8.3.2

Control module SPF 5100

The control module SPF 5100 is connected to the detector outputs of the automatic
SIGMASYS detector (BASE, PL
control module: 10 m).
A floating changeover contact is provided on the output side. Rating 30 V / 1 A.
The control module does not occupy an address on the loop and also supports cross-loop
programming.
Multifunctional Danger Control and Indicating Panels SIGMASYS C and M (M-Modules)
Best.Nr. A24205-A337-B970 – Edition 12 (03/07)
witch is available to enable operation by authorised persons. Four free keys
individually programmed as operating inputs.
els can be installed per MPC module.
cilities.
uired when connecting LEDs to the indicator panel control facility.
rol modules each with 11 C97117-Z3004-C1 relays can be connected to the in-
US, E
short-term by a restart or EMC influences. Con-
e address on the loop. The indicator panel con-
11 rela ys each with 2 potential-free changeovers
3 A / 250 VAC, 5A / 30 VDC, 100 V/0, 5 A/10 W
static or flashing 1 s
XPERT, COMBO) (m
8 Transponders and loop elements
indicating panel.
1500 mm in length and post
ax. line length from detector to the
"
49 / 128