Siemens SIGMASYS C Manual page 125

Feature/Version
SEK emergency alarm
Double MPC SIGMASYS M
Double SOC SIGMASYS M
Standby function for operating panels
Double FDC
Assembly/ commissioning/
maintenance
Display of element addresses and
non-coded text in DIAG
DIAG preliminary version
Functional check via operating panel
Detector LED test via DIAG
NET diagnosis
SW version and HW status with DIAG
Loop periph. plan/actual comparison
via DIAG
Read mainten. req. opt. smoke det.
with DIAG
Status of MPL/detector/element via
DIAG
One-man inspection
One-man inspection Sinteso HFM
Project planning
Configuration diagram
Data export to the GMA Manager
Parameterisation of the control and
indicating panel interfaces
SW service packages with code in-
puts
Foreign-language version of
SIGMASYS C/M
Configuration diagram
Language independent Firmware of
the control and indicaing panel
Detector zone AT correlation via op-
erating panel
PLAN D100 Version:
The control and indicating panels beginning with V2.0 can be programmed with the actual
PLAN D100 V5.1.
Only features that are available in the control and indicating panel's software version can
be programmed, otherwise the entire system will not function correctly.
In the case of software versions 2.2 to 2.4, all control and indicating panels in a SIGMANET
must have the same firmware.
Control and indicating panels and operating panels with the software versions V2.5 and V2.6
and V3.x may be operated in a SIGMANET.
Multifunctional Danger Control and Indicating Panels SIGMASYS C and M (M-Modules)
Best.Nr. A24205-A337-B970 – Edition 12 (03/07)
V2.0 V2.1 V2.2 V2.3 V2.4 V2.5 V2.6 V3.0 V3.1 V3.2 V3.3 V3.5 V3.6 V3.7
06.96 08.96 01.97 5. 97 10.97 04.98 10.99 10.01 4.02
V2.0 V2.1 V2.2 V2.3 V2.4 V2.5 V2.6 V5.0 V5.1 V5.2 V6.0 V6.1 V6.3 V6.4
16 Appendix
02.03 04.04 08.05 04.06 03.07
117 / 128