Maintenance; Calibrating The Scanner - Plustek MobileOffice User Manual

Maintenance

Calibrating the Scanner

Calibrate the scanner if colors appear in areas that should be white, or colors of the
scanned image and the original vary a lot. This allows you to adjust and compensate
for variations which can occur in the optical component over time by its nature.
The following describes how to calibrate the scanner:
1. Insert the special calibration sheet face up into the page feed slot of the
scanner.
Attention
2. Click Start > All Programs > Your scanner model name > Calibration
Wizard. (For Windows 8.1 users: Point your mouse cursor to the upper or lower
right corner of your screen to open the Charm bar. Click on the Start charm,
then click on the downwards arrow button in the lower left corner of the screen.
The Apps screen will be shown. Move your cursor to the right edge of the
screen to scroll right until you find Your scanner model name, and then click
on Calibration Wizard.)
3. Click Next from the Calibration Wizard that pops up and then click Calibrate
Now....
4. Click on the Start button to begin the calibration process.
5. The scanner pulls the calibration sheet through the scanner, which completes
this scanner calibration. After the calibration is complete, click OK and then
click Finish.
Please insert the special calibration sheet included with the
scanner. Alternatively you may also use any plain white
sheet of paper sized in A6 (105 x 148 mm) instead; however,
the calibration effect may be less good than the special
calibration sheet.
16