Operating The Machine - Stiga PRO 18 PRO 16 User Manual

Stiga lawn mower user manual

Hide thumbs

Table Of Contents

Table of Contents

2. Drive position (without symbol).

3. Start position - the electric starter motor

is activated when the key is turned to the

START

spring-loaded start position. Once the en-

gine has started, allow the key to return to

the drive position.

A spare key is enclosed in the plastic bag that also

includes this "instructions for use". Keep this key

in a safe place.

14. CRUISE CONTROL (Pro16 -

Pro18)

A switch for activating the cruise control. The

function of the cruise control allows the drive ped-

al (5) to be locked in the desired position. You do

not need to use the right foot.

1. Depress the drive pedal until the desired

speed is achieved. Then press the rear part

of the switch to activate the cruise control.

The symbol will light up green.

2. Disengage the cruise control by press-

ing the front part of the switch.

15. LIGHT SWITCH (not Classic)

A pull-type switch for the halogen headlamp. The

headlamp works only when the engine is running -

there is no load on the battery. There are two posi-

tions:

1. Switch pulled out - headlamp "on".

2. Switch pushed in - headlamp "off".

16. POWER TAKE OFF (Pro18)

Circuit-breaker for engaging and disengaging the

electromagnetic power take-off.

1. Press the lower part of the circuit-break-

er - the power take-off will be engaged.

The symbol will indicate green.

2. Press the upper part of the circuit-break-

er - the power take-off will be disengaged.

17. HOUR METER (Pro18)

Indicates the number of operating hours. Works

only when the engine is running.

18. ELECTRIC LIFTER (Pro18)

Switch (red symbol) for controlling the front-

mounted, electric lifter.

ENGLISH

1. Press the upper part of the switch - the lifter will

be lowered to the working position.

2. Press the lower part of the switch - the lifter will

be raised to the transport position.

19. EL. CUTTING HEIGHT ADJUST-

MENT (Pro18)

The machine has been designed for electrical ad-

justment of the cutting height (available as an ac-

cessory).

A connection plug is located on the right hand side,

in front of the front wheel.

The switch (orange symbol) is used to adjust the

cutting height up or down in continuously variable

positions.

20. REAR RAKE (Pro18)

The machine has been designed for the use of a

rear rake, which can be raised and lowered electri-

cally (available as an accessory).

Connection cables are located at the rear of the ma-

chine, under the solenoid.

The switch (blue symbol) is used for raising or

lowering the rear rake.