Test Equipment Setup; Equipment Required - Panasonic EB-G60 Service Manual

Calibration Software
This is the test software for the telephone unit and should be installed onto the personal computer to be used for testing.
T5 Screwdriver (Part No. )
This screwdriver is required to remove the case screws from the phone.

7.4. Test Equipment Setup

7.4.1. Equipment Required

PCB
Repair Jig
Handset
IMPORTANT NOTE
To allow accurate measurement of the complete unit the test equipment must be connected as shown,
For testing the handheld unit the following equipment is required:
1. PCB Repair Jig
2. RF Adaptor
3. RF Cable
4. 12 V power supply
5. Personal computer with RS232 interface and running Microsoft Windows
6. Data Cable
7. GSM test station
8. G60 Service software
The G60 Service software should be installed onto the main drive of the personal computer.
The RF cable is connected to the GSM test station via suitable adaptor. The 3.8 V supply is connected
to the RF Adptor and PCB Repair Jig.
NOTE: A suitable test SIM card compatible with the GSM test station will be required.
RF Cable
PCB
Data Cable
PCB TEST SETUP
RF Cable
RF
Adaptor
Data Cable
COMPLETE UNIT TEST SETUP
Figure 7.5. : Test Connection Diagram
GSM Tester
3.8 V DC
Power Supply
PC
GSM Tester
3.8 V DC
Power Supply
PC
95, 98, NT, XP or 2000
®
– 7–4 –