Replacing Engine Oil Filter For Diesel Engines Starting From My 2016; Special Tools And Workshop Equipment Required; Oil Filter Wrench E.g. 3417 , Or Wrench 32 Or - Skoda Rapid NH 2013 Maintenance, Workshop Manual

Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
– Unscrew the screw cap for the oil filter -1-.
– Remove oil filter element -3-.
– Clean the sealing surface on the screw cap for the oil filter and
on the oil filter housing.
– Replace O-rings -2- as well as the oil filter element -3-.
– Tighten the screw cap for oil filter -1- 25 Nm.
– Screw on holder -arrow- with solenoid valve -N345- -1-.
– Attach the cable -2- again.
– After filling with oil, run engine until it is at operating tempera‐
ture and inspect for tightness.
3.4.4 Replacing engine oil filter for diesel en‐
gines starting from MY 2016

Special tools and workshop equipment required

♦ Old oil collection and suction device, e.g. - VAS 6622-

♦ Oil filter wrench e.g. 3417 , or wrench 32 or 36

• Noise insulation removed
– Loosen oil filter -arrow- with oil filter wrench - 3417- .
– Clean sealing surface at engine.
– Lightly moisten the rubber seal of the new filter with oil.
– Screw in the new oil filter.
– Tighten the oil filter -arrow- with an oil filter wrench - 3417- to
the required torque.
Tightening torque
Oil filter
– Drain and fill with engine oil
⇒ "3.10.4 Vehicles with a diesel engine; draining and topping
up with engine oil, starting from MY 2016", page 70
– After filling with oil, run engine until it is at operating tempera‐
ture and inspect for tightness.
– Install the noise insulation.
58
.
Nm
20