Tec-Eye Tm Menu Structure; Tec-Eye Tm Acronyms; Status Screen; Quick Menu - Bard FUSION-TEC HR58APA Installation Support Materials

TEC-EYE Menu Structure
TM

Quick Menu

Setpoints
Information
Alarm Log
Main Menu
System Configuration
Advanced System Configuration
I/O Configuration
On/Off
Alarm Logs
Settings
Logout
In addition to the menu structure above, there are also
Status and Alarm screens.
TEC-EYE Acronyms
TM
MAT – Mixed air temperature
RAT – Return air temperature
OAT – Outdoor air temperature
OAH – Outdoor air humidity
Blower – Indoor blower status
Damper – Free cooling damper position status
CL1 – Compressor stage 1 status
CL2 – Compressor stage 2 status
H1 – Heater stage 1 status
H2 – Heater stage 2 status
ODP – Calculated outdoor dew point
FC – Free cooling status
RN – Component run time in minutes in last hour
ST – Number of start requests in last hour
NOTE: Digital refers to On/Off whereas analog is a
variable input.

Status Screen

The Status screen is the default start-up screen and
also the return screen after 5 minutes of no activity.
The screen can be accessed any time by pressing the
ESCAPE key repeatedly.
The wall-mount unit address is displayed in the upper
right corner on the Status screen (see Figure 2.1). The
Status screen also shows the current date, time, return
air temperature, mixed air temperature, outdoor air
temperature, outdoor humidity and outdoor dew point
conditions. Blower, damper and unit status are also
displayed.
The Quick Menu is accessible from the Status screen.
Setpoints, Information and Alarm Log are available
through the Quick Menu. Pressing the UP or DOWN
keys while on the Status screen will change the Quick
Menu icon displayed (see Figure 2.3). Press the
ENTER key when the desired icon is displayed.
Quick Menu
Setpoints
From this screen, the unit heating and cooling
setpoints can be changed (see Setpoints on page
21). This screen also displays the current cooling and
heating setpoints which when connected to the LV1000
controller will show the heating and cooling setpoints
that are being communicated.
Information
These screens show electronic expansion valve (EEV)
information, run hours, averages and program version
information.
Alarm Log
The alarm log screens show a log of each alarm. There
will be a log for when alarm occurred and if the alarm
auto clears, it will show when the alarm cleared.
FIGURE 2.3
Quick Menu Icons
Data Log Unit Information Setpoints
Page 27 of 53