Directly Entering A Rate - Muratec MFX-1500 Operating Instructions Manual

Getting started

Directly entering a rate

Using the numeric keypad, directly enter the reduction or enlargement rate by doing
one of the following.
Either . . .
1. Press #.
2.
Enter your desired rate using the numeric keypad. You can set any rate from
50% reduction through 200% enlargement.
3.
Press # again.
. . . or . . .
Press or to adjust the rate, at 1% intervals, from/including 50% reduction
through 200% enlargement.
Copy protection
With such a versatile copier built right into your fax machine, you might want to
make sure it doesn't become too tempting to some people whose unauthorised
copying could deplete your machine's supplies more rapidly. So, to limit the use of
your fax machine to only sending and receiving faxes — in other words, to activate
copy protection:
1.
If the machine is in Fax mode, skip to step 2.
Otherwise, press / to change to Fax mode.
COPY FAX
2. Press , , 0, 3,
PROGRAM J ENTER
Copy Protect: Off
Program/Enter
3. Press to turn on copy protection.
PROGRAM
Copy Protect: On
Program/Enter
4.
Press .
ENTER
Copy Protect
** Complete **
1.38
.
While this setting is active, whenever someone tries to change the machine to Copy
mode, the machine will sound a brief alarm tone and display:
Fax Ready
Copy Off
Important: To turn off copy protection off so that you can again use the machine's
copying function, repeat steps 2–4, above (step 1 is unnecessary since
the machine will be in Fax mode) except that, in step 3, you press
so that the display shows:
PROGRAM
Copy Protect: Off
Program/Enter