Technical Specifications; Power Supply Specifications - Siemens RUGGEDCOM RSG2300P Installation Manual

RUGGEDCOM RSG2300P
Installation Guide

Technical Specifications

This section details the specifications and operating conditions of the device.
CONTENTS
• Section 4.1, "Power Supply Specifications"
• Section 4.2, "PoE Power Supply Specifications"
• Section 4.3, "Failsafe Relay Specifications"
• Section 4.4, "Supported Networking Standards"
• Section 4.5, "Copper Ethernet Port Specifications"
• Section 4.6, "Fiber Optic Ethernet Port Specifications"
• Section 4.7, "Operating Environment"
• Section 4.8, "Mechanical Specifications"
Section 4.1

Power Supply Specifications

The RUGGEDCOM RSG2300P can be equipped with the following power supplies:
CAUTION!
Electrical hazard – risk of damage to the device. Disconnect the device from the power supply if power
input is above or below the specified input range.
NOTE
For specifications on the PoE power supply, refer to
Power Supply Type
24 VDC
48 VDC
d
HI (125/250 VDC)
d
HI (110/230 VAC)
a
(F) denotes fast-acting fuse
b
(T) denotes time-delay fuse.
c
Power consumption varies based on configuration. 10/100Base-TX ports consume roughly 1 W less than fiber optic ports.
Power Supply Specifications
Input Range
Minimum Maximum
10 VDC
36 VDC
88 VDC 300 VDC
85 VAC 264 VAC
Section 4.2, "PoE Power Supply
Internal Fuse Rating
36 VDC 6.3 A(F)
59 VDC 3.15 A(T)
2 A(T)
2 A(T)
Chapter 4
Technical Specifications
Specifications".
Maximum Power
ab
c
Consumption
25 W
27