Installing The Cpr Plug; Installing The Therapy Pad; Installing The Power Cord - Invacare MicroAIR 3500S Owner's Operator And Maintenance Manual

Hide thumbs Also See for MicroAIR 3500S:

Table of Contents

SECTION 3—OPERATION

Installing the CPR Plug

NOTE: For this procedure, refer to FIGURE 3.4.

1. Insert the rubber plug into the hose on the head air sack.

NOTE: Moisten the rubber plug if necessary to ease installation.

2. Extend the CPR flag outside the mattress assembly to hang down beside the bed

frame.

A patient should not be placed directly on the mattress without a therapy pad. A

loose (non fitted) cotton sheet between the patient and therapy pad is optional.

A tightly fitted cotton sheet may increase skin friction and shear.

1. Starting at the foot end of the bed, lay the therapy pad (quilted side down) on top of

the mattress.

2. Connect the therapy pad snaps to the corresponding snaps on the straps located on

the mattress (near the bed frame).

1. Plug the power cord into a wall outlet.

NOTE: Verify that air hoses and power cord are clear of moving bed components.

2. Operate all bed motorized functions through their full range.

NOTE: Check for pulling, interference or pinching, and correct any problems.

MicroAIR®3500S

Air Sacks

Rubber

Plug

Mattress

Assembly

CPR Tag

FIGURE 3.4 Installing the CPR Plug

WARNING

Part No 9692006

Table of Contents