Section 3-Operation; Bed Set-Up; Preparing The Bed; Installing The Power Unit - Invacare MicroAIR 3500S Owner's Operator And Maintenance Manual

Hide thumbs Also See for MicroAIR 3500S:

Table of Contents

SECTION 3—OPERATION

WARNING

For patient safety, the bed frame MUST have side rails.

Some homecare beds have adjustable width side rails. Set the side rail width so the

rails touch the mattress. Avoid a gap between the mattress and side rail.

The side rails MUST be in the up position when the patient is lying on the bed.

This mattress is not intended for use on a residential bed.

1. Remove the original bed mattress and place it in storage.

NOTE: For this procedure, refer to FIGURE 3.1.

NOTE: The standard power unit installation is on the upper edge of the footboard.

1. Select the appropriate width swing-out mounting brackets

NOTE: Two sizes are available on the rear panel.

2. Place the power unit on the footboard.

3. Run the power cord under the center of the bed.

Mounting Brackets

FIGURE 3.1 Installing the Power Unit

MicroAIR®3500S

Part No 9692006

Table of Contents

Troubleshooting