Available Aps - Siemens SIMATIC NET SCALANCE W780 Series Configuration Manual

Configuring with Web Based Management
6.4 "Information" menu
● iFeatures
Shows which iFeatures are used.
– -
– iPCF
– iPCF-HT
– iPCF-MC
– iPRP
– iREF
– AeroScout
● State
Shows the status of the WLAN interface.
– enabled
– disabled
6.4.14.7

Available APs

Available access points
Note
This page is only available for clients or access points in client mode.
This page shows all the access points visible to the client. The list also includes the access
points to which the client cannot connect due to its configuration.
Note
Display when iPCF mode is activated
If the iPCF mode is active with a SCALANCE W700, the display is different. Since the client
does not run a background scan in this case, only the access point with which the client is
currently connected is displayed.
162
iFeatures are not used.
The WLAN interface is enabled.
The WLAN interface is disabled.
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13