Client Allowed Channel Settings - Siemens SIMATIC NET SCALANCE W780 Series Configuration Manual

Configuring with Web Based Management
6.3 "Wizard" menu
6.3.1.9

Client Allowed Channel Settings

Introduction
For communication, a specific channel within a frequency band is used. On this page, you
can either set this channel specifically or configure so that the channel is selected
automatically.
Note
This page is only available in client mode.
Description
Table 1 contains the following columns:
● Radio
Shows the available WLAN interfaces.
● Use Allowed Channels only
If you enable the option, you restrict the selection of channels via which the client is
allowed to establish the connection.
In the following tables, you define the channels on which the client searches for an AP.
The tables are divided up according to frequency bands.
If the option is disabled, the channels available based on the settings (country code,
antennas, transmit power etc.) are used.
108
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13