Roland VersaUV LEF2-200 Regular Maintenance Manual page 22

Maintenance That Must Be Performed Daily
Press [ ] to display the screen shown below.
B
MENU
SUB MENU
Press [ ] twice to display the screen shown below.
C
SET AT SETUP
DISABLE DISABLE
Press [ ] or [ ] to select "ENABLE."
D
SET AT SETUP
DISABLE ENABLE
Press [ENTER] to confirm your entry.
E
2.
Set the lower-right corner of the object to be printed on to the base printing position.
Set the base printing position (home position) at the front right of the print area. This method is
appropriate when the print site is level, and you can clearly specify the print area.
Print area setup can be performed with the front cover open. However, if the front cover is left open
for approximately 40 seconds, the print heads automatically return to the home position. The menu
returns to the previous one. Repeat the procedure.
Procedure
Press [ ].
A
Press [ ] twice, and then press [ ] once to display the screen shown below.
B
SET BASE POS.
LOWER R CENTER
Press [ ] [ ] to select "LOWER R."
C
Press [ENTER] to confirm your entry.
D
Press [MENU], then [ ] to go back to the original screen.
E
3.
Attach the object to be printed on for the printing test.
Procedure
Check that the following screen is displayed.
A
SETUP MEDIA
If this screen is not displayed, check that nothing has been placed on top of the flat
table, and then hold down [SETUP] for 1 second or more.
The flat table will come forward into a position in which the object to be printed on can be set
up.
2.Regular Maintenance
20