To Enter Daily Schedule Setpoint - York CodePak YK L1 L1 G4 Operation Manual

To Enter DAILY SCHEDULE Setpoint:

(Refer to Fig. 10.)
1. Press and release DAILY SCHEDULE setpoint key.
The following prompt message is displayed:
SUN START = XX:XX AM, STOP = XX:XX AM
2. If the displayed start and stop time is not the de-
sired schedule, enter the desired start and stop
times as follows:
a. If you do not want the chiller to automatically
start and stop on this day, press CANCEL key.
b. Use the Entry keys to enter desired hours and
minutes start time.
c. If necessary, press the AM/PM key to change
"AM" to "PM" or vice versa.
d. Use the Entry keys to enter desired hours and
minutes stop time.
e. If necessary, press the AM/PM key to change
"AM" to "PM" or vice versa.
3. Press and release ADVANCE DAY/SCROLL key.
The following prompt message is displayed:
MON START = XX:XX AM, STOP = XX:XX AM
4. Enter the desired start and stop time per Step 2.
5. Press and release ADVANCE DAY/SCROLL key.
The following prompt message is displayed:
REPEAT MON SCHEDULE MON-FRI? YES = 1; NO = 0
a. If you press the 1 Entry key, Monday's start and
stop time will be automatically entered for Tues-
day through Friday.
– or –
b. If you press the 0 Entry key, Tuesday through
Friday can be programmed with different start
and stop times.
16
6. Use the ADVANCE DAY / SCROLL key with proce-
dure in Step 2. To enter start and stop times for
remainder of the week plus a holiday schedule if
required.
7. Press the ENTER key.
PROGRAM MODE, SELECT SETPOINT
FIG. 10 – KEYPAD – PROGRAMMING "DAILY
SCHEDULE" SETPOINT
is displayed.
LD01073
YORK INTERNATIONAL