Stamina 55-2065 Owner's Manual page 7

ASSEMBLY INSTRUCTIONS
L
STEP 3
NOTE: "L"
There is a
ASSEMBLY.
Attach the left
"R" RIGHT PEDAL SUPPORT(50)
decal on the
PEDAL RAIL ASSEMBLY
Attach the right
HEX HEAD BOLTS(M8 x 16mm)(74)
Remove
PIVOT(45).
Keep the
PEDAL RAIL ASSEMBLY
right
(M8 x 16mm)(74)
PEDAL SLIDER(51)
NYLOCK NUT(M10)(86)
the left side.
STEP 4:
Attach the
ROUND HEAD BOLTS(M6 x 25mm)(65).
PEDAL CAPS(46)
on the
for foot placement. You will have more vertical movement in the Elliptical stride if you place your feet at the
PEDAL CAPS(46).
back of the
CAUTION:
The lip on the
shown.
LEFT PEDAL SUPPORT(49)
decal on the
PEDAL RAIL ASSEMBLY
PEDAL RAIL CONNECTOR(43)
onto the
LOCK WASHERS(M8)(88).
and
into the hole on the
WASHER(M10)(90).
and
PEDAL CAPS(46)
to fit your shoes. You may select the front or the back of the
PEDAL CAPS(46)
to the left side of the Elliptical unit. There is a
attached to the right
to the right side of the Elliptical unit.
LOCK WASHERS(M8)(88)
and
on the
RIGHT PIVOT(45)
Do not tighten the bolts. Insert the bolt on the
RIGHT PEDAL ARM CONNECTOR(56)
Tighten
LEFT RIGHT PEDAL SUPPORTS(49, 50)
onto the and
PEDAL DIVIDERS(47)
Slide the
must face inside. The sides without a lip face outside as
7
R
attached to the left
PEDAL RAIL ASSEMBLY.
RIGHT PIVOT(45).
HEX HEAD BOLTS
and secure with
BOLTS(M8 x 16mm)(74).
into one of the four slots
PEDAL RAIL
RIGHT
from the
Then insert the
and secure with
Repeat on
with
PEDAL CAPS(46)