Inspection And Test Operation - Samsung AMxxxJXV Series Installation Manual

Drain pipe work
Electrical wiring work
Setting address
Option

Inspection and test operation

Precautions before test operation
When the outdoor temperature is low, turn on the main power 6 hours before beginning the operation.
CAUTION
If you start the operation immediately after turning on the main power, it may cause serious
damage to the part in the product.
Do not touch the refrigerant pipe during or right after the operation.
Refrigerant pipe may be hot or cold during or right after the operation depending on the status of the
Do not operate the product with its panel or protection nets off.
There is risk of personal injury from the parts rotating, heated or with the high voltage.
Do not turn off the main power immediately after stopping the operation.
Wait for at least 5 minutes before turning off the main power. If not, water leakage or other
problems may occur.
Connect all the indoor units and the power supply for the outdoor unit and run auto address
setting. Run auto address setting even after changing the indoor unit PCB.
Have you checked if the drain pipes of the indoor and outdoor unit
are connected together?
Have you completed the drain test?
Is the drain pipe properly insulated?
the terminal board within the range of rated tightening torque?
Have you checked for cross-connection of the power and
communication cables?
Have you performed the earthing work 3 to the outdoor unit?
Did you make sure to use 2-core cable (not multi-core cable) for the
communication cable?
Is the length of the wire within allowed range?
Is the wiring route correct?
Did you set the address of the indoor and outdoor units properly?
Did you set the address of the indoor and outdoor units properly?
(When using multiple remote controllers)
If there is a possibility of the outdoor unit from vibrating, check
whether the anti-vibration frame is correctly installed.
111