Set Up Instructions - Stamina INSTRIDE 55-1615 Owner's Manual

SET UP INSTRUCTIONS

Place the INSTRIDE ELLIPTICAL in the area where it will be used. It is recommended that the INSTRIDE
ELLIPTICAL be placed on an equipment mat. The INSTRIDE
x 17 3/4" wide x 46 3/4" tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 5.5 feet long
is required for safe operation of the INSTRIDE
for access to and passage around the INSTRIDE
LEVELING: Adjust the LEVELING CAPS(44) on the REAR STABILIZER(3) so that the INSTRIDE
ELLIPTICAL sets on the floor without rocking.
MOVING: Grasp the HANDRAIL(7) and REAR STABILIZER(3) to move the INSTRIDE
two people are required for moving. Do not use the Pedal Arms to move the INSTRIDE
ELLIPTICAL. The Pedal Arms will move and may pinch your hand or fingers.
FUNCTION INSPECTION:
Visually inspect the INSTRIDE
Check the function of the INSTRIDE
comfortable position on the handrail. Slowly move your highest foot forward and follow the natural path of
the machine. Turn the crank slowly through one complete revolution to verify that the drive train functions
properly. Adjust the TENSION KNOB(22) and verify that it functions properly.
Locate and read the WARNING LABEL(69) on the INSTRIDE
CAUTION:
all users read the WARNING LABEL(69).
ELLIPTICAL. Make sure that adequate space is available
ELLIPTICAL.
ELLIPTICAL to verify that assembly is as shown in the above illustration.
ELLIPTICAL. Stand on the foot pedals and place your hands at a
10
ELLIPTICAL is approximately 33 1/2" long
Equipment Mat
ELLIPTICAL. Make sure that
ELLIPTICAL,