Contractor Menus - Weil-McLain SVF 1500 Manual

SVF
™
Series 1
Commercial Condensing Gas-Fired Water Boiler — Boiler Manual

CONTRACTOR menus

cal settings.
severe personal injury, death or substantial property
damage.
Figure 66
control menu access — accessing contractor menus
TM
ni
Screens shown above are typical
only. Actual screens depend on
control settings chosen.
74
Failure to set correctly could result in
USER MODE
BOILER
SETTINGS
PRIORITY 1
PRIORITY 2
PRIORITY 3
ASSIGN INPUTS
DIAGNOSTICS
MAINTENANCE
INFO
SET TIME &
DATE
-
1. Access contractor menus by pressing and holding the UP and
DOWN arrow keys at the same time for 7 seconds.
2. See the following pages for explanations of control setting options.
The default for this setting is
in this manual assume the USER MODE is set to BASIC. For
advanced features available in ADVANCED mode, see the
TM
SVF
Advanced Manual.
Set/change boiler model, control type,
high altitude setting, ODT sensor require-
ment, manual reset, high limit and WWSD
temperature settings, outdoor sensor temp
adjustment, circulator exercising, freeze
protection setup, and restore to factory
default option.
These settings control operating tempera-
tures and behaviors for systems that are
assigned to "PRIORITY 1."
These settings control operating tempera-
tures and behaviors for systems that are
assigned to "PRIORITY 2."
These settings control operating tempera-
tures and behaviors for systems that are
assigned to "PRIORITY 3."
These settings assign Priority 1, 2 or 3 to
each of the three inputs to the control.
Use to review current and historical infor-
mation including previous lockouts.
Used to set contractor contact information,
boiler information and maintenance dates.
Use to set date and time — important since
fault occurrences are date/time stamped.
information
mode. Screens shown
See page 75
See page 76
See page 76
See page 76
See page 77
See page 79
See page 84
None
Part number 550-100-250/0819