Contractor Menus - Weil-McLain Eco Tec 2 Series Advanced Manual

®
ECO Tec series 2 gas-fired water boiler – advanced manual

CONTRACTOR menus

Boiler Model, Altitude and Fuel Type are
critical settings. Failure to set correctly could
result in severe personal injury, death or substantial
property damage.
Figure 28 ECO Tec Control menu access — accessing contractor menus
CONTRACTOR MENU
BOILER SYSTEM
DIAGNOSTICS
SETTINGS SETTINGS
MODBUS NETWORK
SETTINGS SETTINGS
Screens shown above are typical only.
Actual screens depend on control settings
chosen.
– 58 –
MENU Item
BOILER
SETTINGS
SYSTEM
SETTINGS
SERVICE INFO
DIAGNOSTICS
SERVICE INFO
MODBUS
SETTINGS
NETWORK
SETTINGS
1. Access contractor menus by pressing and holding the WM
Logo for 7 seconds from the home screen.
2. See the following pages for explanations of control setting op-
tions.
PURPOSE
• Set/change boiler model, control type,
high altitude setting, Outdoor Temp sen-
sor requirement, manual reset high limit
and WWSD temperature settings, outdoor
sensor temp adjustment, circulator exercis-
ing, freeze protection setup, and restore to
factory default option, fuel type and blower
calibration.
• These settings assign Priority 1, 2 or 3 to
each of the four inputs to the control and see
an overview of assigned priorities.
• Use to review current and historical infor-
mation including previous lockouts.
• Used to set contractor contact information,
boiler information and maintenance dates.
• Used to adjust Modbus related settings such
as Baud Rate, Parity and Stop Bits, Modbus
Address and turning Modbus on/off.
• Used to adjust Max Time for Net, Min Time
for Net, Max Rate for Net, Min Rate for Net
and select Rotation and Sequence screen.
More
information
See page 59.
See page 64.
See
ECO Tec
Boiler Manual.
See page 72.
See
ECO Tec
MODBUS
Supplement.
See page 60.
Part number 550-100-272/1021