Table of Contents
Advertisement
™
SlimFit
COMMERCIAL CONDENSING GAS
CONTRACTOR menus
Failure to set correctly could result in
severe personal injury, death or substantial property
damage.
SlimFit control menu access — accessing contractor menus
Screens shown above are typical
only. Actual screens depend on
control settings chosen.
66
—
-
FIRED WATER BOILER
1. Access contractor menus by pressing and holding the UP and
DOWN arrow keys at the same time for 7 seconds.
2. See the following pages for explanations of control setting
options.
The default for this setting is
in this manual assume the USER MODE is set to BASIC. For
USER MODE
advanced features available in
SlimFit
Set/change boiler model, control type,
high altitude setting, ODT sensor require-
ment, manual reset, high limit and WWSD
BOILER
temperature settings, outdoor sensor temp
SETTINGS
adjustment, circulator exercising, freeze
protection setup, and restore to factory
default option.
These settings control operating tempera-
PRIORITY 1
tures and behaviors for systems that are
assigned to "PRIORITY 1."
These settings control operating tempera-
PRIORITY 2
tures and behaviors for systems that are
assigned to "PRIORITY 2."
These settings control operating tempera-
PRIORITY 3
tures and behaviors for systems that are
assigned to "PRIORITY 3."
These settings assign Priority 1, 2 or 3 to
ASSIGN INPUTS
each of the three inputs to the control.
Use to review current and historical infor-
DIAGNOSTICS
mation including previous lockouts.
MAINTENANCE
Used to set contractor contact information,
boiler information and maintenance dates.
INFO
SET TIME &
Use to set date and time — important since
fault occurrences are date/time stamped.
DATE
Boiler Manual Series 2
Advanced Manual.
Part number 550-100-162/0815
mode. Screens shown
mode, see the
See page 67
See page 68
See page 68
See page 68
See page 69
See page 71
See page 76
None
Advertisement
Table of Contents
