Contractor Menus - Weil-McLain Evergreen 220 User Manual

™ GAS

CONTRACTOR menus

Failure to set correctly could result in
severe personal injury, death or substantial property
damage.
Evergreen control menu access — accessing contractor menus
Part number 550-100-131/0715
-
FIRED WATER BOILER
USER MODE
BOILER
SETTINGS
PRIORITY 1
PRIORITY 2
PRIORITY 3
ASSIGN INPUTS
DIAGNOSTICS
MAINTENANCE
INFO
SET TIME &
DATE
— Boiler Manual
1. Access contractor menus by pressing and holding the UP and
DOWN arrow keys at the same time for 7 seconds.
2. See the following pages for explanations of control setting
options.
The default for this setting is
in this manual assume the USER MODE is set to BASIC. For
advanced features available in
Evergreen
Advanced Manual.
Set/change boiler model, control type,
high altitude setting, ODT sensor require-
ment, manual reset, high limit and WWSD
temperature settings, outdoor sensor temp
adjustment, circulator exercising, freeze
protection setup, and restore to factory
default option.
These settings control operating tempera-
tures and behaviors for systems that are
assigned to "PRIORITY 1."
These settings control operating tempera-
tures and behaviors for systems that are
assigned to "PRIORITY 2."
These settings control operating tempera-
tures and behaviors for systems that are
assigned to "PRIORITY 3."
These settings assign Priority 1, 2 or 3 to
each of the three inputs to the Evergreen
control.
Use to review current and historical infor-
mation including previous lockouts.
Used to set contractor contact information,
boiler information and maintenance dates.
Use to set date and time — important since
fault occurrences are date/time stamped.
mode. Screens shown
mode, see the
See page 74
See page 75
See page 75
See page 75
See page 76
See page 78
See page 83
None
– 73 –