Table of Contents
Advertisement
After the bypass nozzles
have been fitted or
replaced
7.
Remove the four ignition switches.
For models with a burner safety device
Use a screwdriver (no. 2) for slotted screws to tighten
the nozzles above as far as possible.
Refit the control panel:
1.
Grip the panel with both hands and slowly fit it into
place. Caution: do not damage the cable or break
the connections. Lower it slightly and place it in the
fastening brackets.
2.
Screw in the two function selector screws again.
3.
Insert both screws (T20) (M4) in openings 1 and 4
from the right hand side.
4.
Fasten the front two screws (T20) on the left and
right. Refit the plastic cover.
5.
Screw the two screws (T20) on the front left and
right on the hob.
6.
Refit the cover plate if necessary.
1.
Fit the control knobs carefully.
2.
Check the burning behaviour of the gas burners.
See the "Safe burning behaviour" section.
3.
Check whether the appliance functions perfectly.
21
Hide quick links:
Advertisement
Table of Contents
