Defining Switch Module Ip Addresses; Defining Default Gateways - Dell PowerConnect 5316M User Manual

The following is an example of the CLI commands:
console> enable
console# configure
console(config) # logging 10.1.1.1 severity critical
console(config)# end
console# show logging
Logging is enabled.
Console Logging: Level debug. Console Messages: 5 Dropped.
Buffer Logging: Level debug. Buffer Messages: 16 Logged, 16
Displayed, 200 Max.
File Logging: Level error. File Messages: 0 Logged, 209 Dropped.
SysLog server 31.1.1.2 Logging: error. Messages: 22 Dropped.
SysLog server 5.2.2.2 Logging: info. Messages: 0 Dropped.
SysLog server 10.2.2.2 Logging: critical. Messages: 21 Dropped.
SysLog server 10.1.1.1 Logging: critical. Messages: 0 Dropped.
1 messages were not logged
03-Mar-2004 12:02:03 :%LINK-I-Up: g11
03-Mar-2004 12:02:01 :%LINK-W-Down: g12
03-Mar-2004 12:02:01 :%LINK-I-Up: g13

Defining Switch Module IP Addresses

The IP Addressing page contains links for assigning interface and default gateway IP addresses, and
defining ARP and DHCP parameters for the interfaces. To open the IP Addressing page, click
→
System IP Addressing in the tree view.

Defining Default Gateways

The Default Gateway page contains fields for assigning Gateway to Ethernet switch modules.
Packets are forwarded to the default IP when packets are sent to a remote network. The configured
IP address must belong to the same IP address subnet of one of the IP interfaces. To open the
Default Gateway page, click System
The Default Gateway page contains the following fields:
102
Configuring System Information
→ →
IP Addressing Default Gateway in the tree view.