Parameter Settings - Mitsubishi Electric Melsec QJ71LP21 Reference Manual

5

PARAMETER SETTINGS

5 PARAMETER SETTINGS
Start parameter settings.
Construct a single
network system?
Yes
5
Construct multiple
network systems?
Yes
See parameter list (4)
shown in this chapter.
5 - 1
To run the MELSECNET/H, the parameters for the network module mounted to the
programmable controller CPU must be set with GX Developer.
Depending on the network configuration, some parameters must be set, some must be
set as required, and some do not.
The following pages provide lists of parameter settings required for each network
configuration.
No
No
Construct a
redundant system?
Yes
See parameter list (1)
shown in this chapter.
Construct multiple
network systems?
Yes
See parameter list (4)
shown in this chapter.
No (Construct a simplified redundant system.)
No
See parameter list (2)
shown in this chapter.
Construct multiple
network systems?
Yes
See parameter list (4)
shown in this chapter.
MELSEC-Q
No
See parameter list (3)
shown in this chapter.
5 - 1