Removing The Carrier Module For The Interface Module - Siemens SIMATIC ET 200SP HA System Manual

Removal

7.6 Removing the carrier module for the interface module

7.6 Removing the carrier module for the interface module
Tools required
Screwdriver 4.5 mm or TORX T15 (recommended): For loosening the fixing screws for the rail.
Initial situation
The IO device is wired. There are additional components (carrier modules and I/O modules) to
the right of interface module.
Requirement
● The supply voltages for this IO device are shut off.
● All adjacent components to the right (carrier modules or server module) have been
removed.
You can find information on this in the following sections:
– Section "Removing a server module and power bus cover (Page 103)"
– Section "Removing a terminal block (Page 105)"
– Section "Removing the carrier module (Page 108)"
– Section "Removing the interface module (Page 111)"
● There must be at least 8 mm of clearance to adjacent carrier modules.
112
ET 200SP HA Distributed I/O system
System Manual, 08/2019, A5E39261167-AD