Removing The Carrier Module - Siemens SIMATIC ET 200SP HA System Manual

Removal

7.3 Removing the carrier module

7.3 Removing the carrier module
Tools required
● Screwdriver 4.5 mm: For removing the interlocks (1 and 2) of the carrier module
● Screwdriver 4.5 mm or TORX T15 (recommended): For loosening the fixing screws for the
rail.
Requirements
● The supply voltages are switched off.
● All terminal blocks are remote from the carrier module.
Note
Adjacent components
To remove a specific carrier module, you need to remove the adjacent components on the right
(carrier modules or server module). Once there is clearance of approx. 8 mm to the adjacent
carrier modules, you can remove the carrier module.
● There are no other components to the right next to the carrier module.
108
ET 200SP HA Distributed I/O system
System Manual, 08/2019, A5E39261167-AD