Saving The Parameterisation Data - Siemens SITRANS LG260 Operating Instructions Manual

Additional settings - Spe-
cial parameters
Info - Instrument name
Info - Instrument version
Info - Factory calibration
date
Info - Sensor character-
istics
Backup on paper
Backup in the display and
adjustment module
PBD-51041059
The default setting is "Analogue current output" and the address 00.
In this menu item you gain access to the protected area where
you can enter special parameters. In exceptional cases, individual
parameters can be modified in order to adapt the sensor to special
requirements.
Change the settings of the special parameters only after having con-
tacted our service staff.
In this menu, you read out the instrument name and the instrument
serial number.
In this menu item, the hardware and software version of the sensor is
displayed.
In this menu item, the date of factory calibration of the sensor as well
as the date of the last change of sensor parameters are displayed via
the display and adjustment module or via the PC.
In this menu item, the features of the sensor such as approval, pro-
cess fitting, seal, measuring range, electronics, housing and others
are displayed.
Example for displayed sensor features.
6.6

Saving the parameterisation data

We recommended writing down the adjustment data, e.g. in this op-
erating instructions manual, and archiving them afterwards. They are
thus available for multiple use or service purposes.
If the instrument is equipped with a display and adjustment module,
the data in the sensor can be saved in the display and adjustment
module. The procedure is described in menu item "Copy device
settings" in the menu "Additional settings". The data remain there
permanently even if the sensor power supply fails.
SITRANS LG260 - Operating Instructions
41