Southbend SEZ/3 Operator's Manual page 10

I
NSTALLATION
Step 4: Water Connection
Do not connect steamer to a hot water line. A hot water connection will damage the steamer.
To meet warranty requirements, the supply water must meet the following specifications:
Pressure
Total Dissolved Solids (TDS)
Hardness
pH
Connect a cold water line to the water inlet strainer on the back of the steamer, as shown in Figure 4 on
page 9. The connector on the unit is 1/4" NPT male.
NOTE: To facilitate cleaning, and allow access to rear of unit, flexible connections are recommended. A shut
off valve at (or near) the rear of the unit is highly recommended. See Figure 5 below.
Figure 5
Cold
Water
Supply
P 10
AGE
!
WARNING
NOTICE
30 to 60 PSI
60 PPM
2 grains or 35 PPM
7.0 to 7.5
Shut Off Filter
Valve
O
SEZ S C
ERIES OUNTERTOP
Check
Valve
' M 1183437
PERATOR S ANUAL
S
TEAMERS
Steamer