Sinumerik 840D Sl With Safety Integrated (System-Integrated) - Siemens SINUMERIK 828D Function Manual

A.1.3

SINUMERIK 840D sl with Safety Integrated (system-integrated)

1) DOCUMENTATION
Documentation of the machine including the safety functions
1.1 Machine description (with overview diagram)
1.2 Details about the control system
1.3 Configuration diagram
1.4 Function table
1.5 SI functions per axis
1.6 Information and data about safety equipment
2) FUNCTION TEST PART 1
General function check incl. checking the wiring/programming/configuring
2.1 Testing the switch-off signal paths
2.2 Test the external stops
2.3 Test of the holding torque
2.4 Testing the forced checking procedure of the inputs and outputs
2.5 Testing the Emergency Stop function and the safety circuits
2.6 Test all SPL switching states and associated input/output signals
2.7 Test of the PROFIsafe input/output signals
Recommendation:
A forced checking procedure should be automatically performed each time that the control
system runs up.
3) FUNCTION TEST PART 2
Detailed function test incl. checking the values of the individual SI functions used
3.1 Test of the SI function Safe Operating Stop – SBH
3.2 Test of the SI function safely reduced speed - SG
3.3 Test of the SI function safety-related output n < n
3.4 Test the SI function safe limit positions – SE
SINUMERIK Operate acceptance test
Function Manual, 08/2018, A5E39460574B AC
Active monitoring functions depending on the operating mode, the protective doors and
other sensors/CPU-CPU communication
Ideally, this table should be the objective and result of the configuring work.
(check the forced checking procedure of the switch-off signal paths)
(test of the function table)
(with evaluated measurement diagram or measured values)
(with the evaluated measurement diagram or measured values)
(with evaluated measurement diagram or measured values)
(with evaluated measurement diagram or measured values)
A.1 Example contents of the acceptance test
x
Appendix
87