Effects With Sinumerik 840D Sl Safety Integrated Plus - Siemens SINUMERIK 828D Function Manual

Actions for hardware replacement and modifications
5.2 Effect of the acceptance test for specific measures
Measure Documentation
SPL change Inclusion of the SI
function per axis,
function table
Data transferred to Possibly supple‐
additional ma‐ ment, machine de‐
chines with series scription (check
commissioning the SW version)
Regarding the acceptance test, the notes in the documentation of the SW upgrade must be carefully observed.
1
An update involves an update to a new Service Pack (SP) or a new Hotfix (HF) within a software line, e.g. 02.05.01.03 (01
2
= Service Pack; 03 = Hotfix) to 02.05.02.03 (does not take into account any change of the Safety functionality).
An upgrade involves an upgrade to a new software release, e.g. 02.05.xx.xx to 02.06.xx.xx or 02.xx.xx.xx. to 03.xx.xx.xx
3
(does not take into account any change of the Safety functionality).
If no checksums have changed, then a complete function test, Part 2 does not have to be performed. However, a test
4
should be performed with reduced test scope.
Note
Test with reduced test scope
Test of Safety Integrated Functions at any axis (each NCU and each NX) and a comparison
with the test results before the upgrade.
Note
If the results of function test, Part 2 are taken from another identical machine, then this is the
sole responsibility of the machine manufacturer and should be appropriately commented in
the acceptance report.
5.2.3

Effects with SINUMERIK 840D sl Safety Integrated plus

The effects of the acceptance test with certain measures are described in the following table.
Function test parts 1 and 2, as well as the supplementary measures relate to the section
Example contents of the acceptance test (Page 90).
Measure
Replacement of the encoder
system
Replacing an SMC, SME mod‐
ule
Replacing a motor equipped
with DRIVE-CLiQ
80
Function test
Part 1
Yes, only Point 2.6
(Page 87)
Yes
Documentation
Supplement hardware
data
Supplement hardware
data/software version da‐
ta
Supplement hardware
data/software version da‐
ta
Function test Supplementary
Part 2 measures
No No
No Points 4.1 and 4.5
(Page 87)
Function test Function test
Part 1 Part 2
No No
No No
No No
Function Manual, 08/2018, A5E39460574B AC
Completion of the
report
Document
changed check‐
sum
Document
changed check‐
sum
Supplemen‐ Completion of
tary meas‐ the report
ures
Point 4.1 Document
(Page 90) changed check‐
sum
Point 4.1 Document
(Page 90) changed check‐
sum
Point 4.1 Document
(Page 90) changed check‐
sum
SINUMERIK Operate acceptance test