Siemens SINUMERIK 828D Function Manual page 43

Table 3-2
Program code
[TESTFR]
TestName=open door, axis = %1, number = %4
Two test cases are performed in the acceptance test for test type "Function relations"
● Test case 1: Axis X1
● Test case 2: Axis Y1
The following are displayed or entered for the test cases at the user interface of the acceptance
test, in the certificate and in the customized template:
● Test case 1: Open door, axis = X1, number = 1
● Test case 2: Open door, axis = Y1, number = 2
Test type-specific sections
Section
[TESTPD]
[TESTXS]
[TESTSPL]
[TESTES]
[TESTFR]
[TESTPOS]
[TESTSTO]
[TESTSS1]
[TESTSS2]
[TESTSBH]
[TESTSOS]
[TESTSG]
[TESTSLS]
[TESTSSM]
[TESTSE]
[TESTSLS]
[TESTSBH]
[TESTSBH]
[TESTSDI]
File information
File name:
Siemens path (source):
User path (target):
Editor:
SINUMERIK Operate acceptance test
Function Manual, 08/2018, A5E39460574B AC
3.2 SINUMERIK 828D/840D sl - drive-based Safety functions
File: .../user/sinumerik/hmi/cfg/slatw.ini
Test type
Switch-off signal path
External stops
SPL inputs/outputs
Emergency Stop
Function relations
Position adjustment
STO - Safe Torque Off
SS1 - Safe Stop 1
SS1 - Safe Stop 2
SBH - safe operating stop
SOS - Safe Operating Stop
SG - Safely reduced speed
SLS - Safe Limited Speed
SSM - Safe Speed Monitoring
SE - safe software limit switch
SLP - Safe Limited Position
SBT (SINUMERIK) - safe brake test
SBT (SINAMICS) - Safe Brake Test
SDI - Safe Direction
slatw.ini
.../siemens/sinumerik/hmi/cfg
.../user/sinumerik/hmi/cfg
Any editor, saved in the ASCII format
Acceptance test wizard of SINUMERIK Operate
43