Introduction; Purpose And Requirements - Siemens SINUMERIK 828D Function Manual

Introduction

2.1

Purpose and requirements

The goal of the acceptance test is to check the correct parameterization and mode of operation
of the safety functions and to detect potential configuration errors or to document the
correctness of the configuration.
During this acceptance test, the limit values entered for all of the activated safety functions
must be violated so that the proper execution of the function can be checked and verified.
Note
The machine manufacturer is responsible for carrying out and documenting the acceptance
test. You will find examples of complete acceptance tests for 828D and 840D sl in the annex.
See also: Scope of an acceptance test (Page 85)
Note
Use of the results of the acceptance tests for any other purpose is not permitted!
The values (e.g. distance, time) measured and the system behavior (e.g. initiation of a specific
stop) determined during the acceptance test are used for a plausibility check of the configured
safety functions. The recorded measured values are typical and are not worst-case values.
They represent the behavior of the machine at the time of measurement. These measurements
cannot be used to derive real values (e.g. maximum paths for over-travel distances).
Danger to life due to unwanted motion due to incorrect parameter changes
Changes to accepted safety functions may lead to errors or to unwanted movements and
thus to serious injuries or death.
After changes have been made to safety functions (e.g. by changing relevant parameters),
a new acceptance test of the changed safety function must be performed and recorded in the
acceptance report.
See also: Actions for hardware replacement and modifications (Page 75)
SINUMERIK Operate acceptance test
Function Manual, 08/2018, A5E39460574B AC
WARNING
2
15