Ping - Denso BHT-1260BWB-CE User Manual

BHT-1200 Series

4.7.7 Ping

Tap the "Ping" tab in the WWAN manager to check the WWAN
communication status.
The screen on the right is displayed.
Destination IP
Interval
OK / Total
- Note -
Refer to "4.7.2 General" for the details of the
"Network" and "Data Connection" section.
"Start" / "End" button : Starts or ends pinging.
"Option" button
OK Sound
NG Sound
Dialog Color
Group
Ping
Network
Data Connection
File save
File path
File name
Log contents
- Note -
GPS data will be obtained in a few minutes after the ping is started.
The BHT will not be turned OFF while pinging.
162
: Sets the destination device IP address
: Sets the ping time interval
; Displays the ping results.
Ping success count / Ping total count
: Sets the ping options.
: Plays an OK sound when a ping succeeded.
: Plays an NG sound when a ping timeout occurs.
: Uses the background color for each dialog
group to classify the status by color.
Status
Color
Ping succeeded.
Green
Ping timeout occurred.
Red
4 or more antennas exist.
Green
3 or less antennas exist.
Yellow
1 or none antenna exists.
Red
Green Data connection is connected
Red Data connection is disconnected
: Saves the ping logs in the following file.
: \Flash\3Glog
: $3Glog_"serial number of the device".log
: time(hh:mm:ss), ping status(OK/NG), BHT IP address, carrier name,
network status, signal strength, base station ID, GPS latitude and longitude.