General - Denso BHT-1260BWB-CE User Manual

4.7.2 General

Tap the "General" tab in the WWAN manager.
The screen on the right is displayed.
Tap the "Power ON" button to turn ON the WWAN module.
Tap the "Power OFF" button to turn OFF the WWAN module.
The following information is displayed when the WWAN module is ON.
Section Item
SIM Status
Phone Number
Network Carrier
Status
Signal Strength
Data Connection
Connection
APN
Status
- Note -
If the above information is not shown, tap the "Power OFF" button then tap the "Power
ON" button to restart the WWAN module.
If the internet connection is disconnected, tap the "Disconnect" button then tap the
"Connect" button to reconnect to the internet.
The "Connect" and "Disconnect" button will be enabled when data connection settings are configured.
Tap the "Connect" button to start data connection, and tap the "Disconnect" button to stop data connection.
Refer to 4.7.3 DataConnection – [1] Data connection setup for details.
Barcode Handy Terminal/2D code Handy Terminal
Value
Removed
Ready
Waiting for PIN1
Waiting for PUK1
-
No Service
(Carrier name)
GPRS available
GPRS in use
EGPRS available
EGPRS in use
3G available
3G in use
HSDPA available
HSDPA in use
HSDPA/HSUPA available
HSDPA/HSUPA in use
0 - 100
(Connection name)
(Access point name)
Disconnected
Connected
Hand Held Terminal
Barcode Handy Terminal
Meaning
The SIM card is not inserted or the
WWA module is not turned ON.
The SIM card is ready to use.
Waiting for PIN1 to be entered.
Waiting for PUK1 to be entered.
Phone Number
Out of service area, or the WWAN
module is not turned ON.
GPRS is available
GPRS is in use
EGPRS is available
EGPRS is in use
3G is available
3G is in use
HSDPA is available
HSDPA is in use
HSDPA/HSUPA is available
HSDPA/HSUPA is in use
Signal Strength
The connection name set in the data
connection tab menu.
The access point name set in the
data connection tab menu.
Data connection is disconnected.
Data connection is connected.
W
157