Denso BHT-1260BWB-CE User Manual page 138

BHT-1200 Series
[1] New
To create a new network profile, tap the "New" button in the Profiles tab
screen.
The following menus are displayed in the Profiles screen.
The menus shown in the screen will vary depending on the settings
selected for the Authentication, Encryption and EAP type.
SSID: Enter an SSID (service set identifier) that identifies the wireless
network. (1 to 32 ASCII characters)
Authentication:
Select the authentication method from the pull-down list.
Encryption:
Select the encryption method from the pull-down list.
WEP / Pre Shared key:
The WEP key is displayed only when the WEP is selected and the EAP type is disabled.
The WEP Key can be entered as 26 hexadecimal characters (128 bits), 10 hexadecimal
characters (40 bits), 13 ASCII characters (128 bits) or 5 ASCII characters (40 bits).
The Pre Shared key is displayed when the WPA-PSK is selected.
The Pre Shared Key can be entered as 8 to 63 ASCII characters or 64 hexadecimal characters.
Key Index:
Select the Key index from 1 to 4 then enter the WEP Key.
EAP type:
Select the EAP type for the 802.1x wireless network security.
User ID:
Enter the user ID as 0 to 64 ASCII characters.
Password:
Enter the password as 0 to 64 ASCII characters.
Anonymous ID:
Enter the anonymous ID as 0 to 64 ASCII characters.
Issued to:
The destination of the specified client certificate is displayed.
Issued by:
The source of the specified client certificate is displayed.
Validate Server:
Check the box to verify the server certificate with the existing root certificate which is previously
imported.
PAC Provisioning:
Select the PAC provisioning mode.
126