Router Port - TRENDnet PoE Web Smart Switch Series User Manual

TRENDnet User's Guide

Router Port

Network > MLD Snooping > Router Port
1. Log into your switch management page (see
on page 5).
2. Click on Network, click on MLD Snooping, and click on Router Port.
3. Review the settings. Click Modify to change the settings. Click Apply to save the
settings.

VLAN ID – Shows the VLAN ID.

Static Router Port – Shows if/what the static router ports are.

Dynamic Router Port – Shows if/what the dynamic router ports are.

802.1Q VLAN ID – Shows the VLAN ID.

Static Router Port – Check the box below the port number to set the statically
set ports
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
PoE Web Smart Switch Series
55