Binding - TRENDnet PoE Web Smart Switch Series User Manual

TRENDnet User's Guide

Binding

Security > DHCP Snooping > Binding
The Binding Database displays learned and statically assigned MAC
Address and IP Address information for each host on the local area network.
Dynamically assigned IP addresses from the DHCP server will automatically populate the
table on the Binding Database page as they are assigned by the server. Statically
assigned IP addresses are entered manually by entering the host's address information
and clicking on the Add button.
1. Log into your switch management page (see
on page 5).
2. Click on Security, click on DHCP Snooping, and click on Binding.
3. Review the settings. Click Add to add the database entry to the table.

MAC Address - Enter the host's MAC Address.

IP Address - Enter the static IP Address assigned to the host.

VLAN - Enter the host's VLAN ID.

Port - Enter the port number where the host is connected.

Type - Because the IP Address being entered is static, you must select Static.

Lease Time - Enter the time that IP address assignment is valid. The range is 10
to 4294967295 seconds.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
You can also click Delete All to delete all of the entries in the table. If the entries span
multiple pages, you can navigate page number in the Page field and click Go or you can
click First, Previous, Next, and Last Page to navigate the pages.

MAC Address: This parameter shows the host's MAC Address.

VLAN ID: This parameter shows the host's VLAN ID of which the DHCP client is
a member.

IP Address: This parameter is the IP Address assigned by the DHCP server to
the DHCP client.

Port: This parameter is the port number where the DHCP client is connected.

Type: This parameter indicates the following:

Learned-The host IP Address is dynamically assigned by the DHCP server.

Static- The host IP Address is statically assigned. See "Static IP Addresses" on
page 300 for more information.

Lease Time: This parameter is the time that IP address assignment by the DHCP
server is valid.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
PoE Web Smart Switch Series
92