Mst Port - TRENDnet PoE Web Smart Switch Series User Manual

TRENDnet User's Guide

MST Port

Network > Spanning Tree > MST Port
1. Log into your switch management page (see
on page 5).
2. Click on Network, click on Spanning Tree, and click on MST Port.
3. Review the settings. For each entry, click Apply to save changes.

Select MST Port – Click the drop-down to select which MST port to configure.

MST Port Info - The MST Port Information page provides user to configure the
MSTP Interface settings.
o
Admin Path Cost (0 = Auto) - This is the port cost used by MSTP when
calculating path cost to the root bridge.
o
Priority - This is the port priority used by MSTP in calculating path
costs when two ports on the switch have the same port cost.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"
PoE Web Smart Switch Series
45