Lexmark 6200 Series Service Manual page 36

4411-XXX
FRU / Function
2 Color print
cartridge cross
contamination
3 Maintenance
Station
4 Paper Feed
5 Carrier Transport
2-16
Service Manual
Action
Be sure the print cartridge nozzle plate is clean.
Clean with a soft cloth.
If cross contamination occurs, check for:
• Maintenance station wiper damage.
• Used tape on the printhead nozzle plate.
If wiper damage is found, replace the maintenance
station. Go to the
removal" on page
Note: Do not retape the printhead nozzle plate.
Intermittent nozzle failures can be caused by worn
parts in the maintenance station. If worn parts are
detected, replace the maintenance station. Go to
the "Maintenance station removal" on
page 4-13.
Ink smudging and smearing can be caused by
paper problems or problems in the paper feed
area. Check for:
• Correct type of paper
• Curled or wrinkled paper
• Paper path obstructions
• Feed roller wear or looseness
• Worn gears or binds
If the paper feed roller or gears are defective,
replace the print engine. Go to the
removal" on page
Blurred print and voids can be caused by problems
in the carrier transport area. Check the following:
• Carrier transport belt for wear
• Idler pulley parts for wear, damage, or
looseness
• Carrier guide rod for wear or dirt. If dirty, clean
and lubricate.
Carrier to carrier frame engagement should be
lubricated with grease P/N 99A0394.
If the carrier transport belt is worn, replace the
carrier assembly. Go to the
removal" on page
If the idler pulley parts are defective, replace the
print engine. Go to the
page 4-7.
"Maintenance station
4-13.
4-7.
"Carrier assembly
4-10.
"Print engine removal" on
"Print engine