Table of Contents
Advertisement
4411-XXX
Non-catastrophic error
In this state, an error has occurred, but the All-In-One can continue to
operate. You may need to intervene using a button press, or the machine
may time out and return to the Error! Reference source not found state,
depending upon the error. The All-In-One will continue to accept and
respond to data until its buffers are full. In general, the entire device is in the
non-catastrophic error state, but only the logical device with the error
changes its behavior.
Non-catastrophic error list
Code
Name
1003
Paper
Calibrate
Failure
1102
Incorrect
Printhead
1201
Print
Incomplete
2-4
Service Manual
Description
Failure in initializing or
calibrating DC paper
feed system.
Printhead ID is not
valid.
The print carrier
stopped before all of
the data was used.
Action
Unplug the All-In-One;
wait a few seconds,
then plug the
All-In-One back in and
turn the power on. If
the error remains,
check for voltage
(approximately 5 V dc)
on pin 2 of J15. If
okay, verify voltage at
the Encoder card as
well (same pin at
Encoder card end). If
there is no voltage at
J15-pin 2, replace the
system board. If there
is no voltage at the
Encoder card end, but
okay at J15, replace
the print engine.
Replace the print
cartridge(s).
Resend the print job.
Advertisement
Table of Contents
