Troubleshooting - Sony SLV-N80 Operating Instructions Manual

Troubleshooting

If you have any questions or problems not covered below, please consult your nearest Sony
dealer.
Symptom
The ?/1 switch does not function.
The power is turned on but the VCR
does not operate.
The clock has stopped and "–:– –"
appears in the display window.
"ACS" flashes in the display window. • The VCR is searching for a time signal. If channels in
The playback picture does not appear
on the TV screen.
The picture is not clear.
The picture rolls vertically during
picture search.
The picture has no sound.
A TV program does not appear on
the TV screen.
TV reception is poor.
The tape starts playing as soon as it is
inserted.
The tape is ejected when you press
z REC.
Nothing happens when you press
z REC.
Remedy
• Connect the AC power cord securely.
• Make sure the VCR is not locked. To unlock, hold down
?/1 POWER on the VCR until the - indicator
disappears.
• Moisture condensation has occurred. Turn the power off,
unplug the AC power cord and leave the VCR to dry for
over three hours.
• The clock stops if the VCR is disconnected from the wall
outlet for more than one hour. Reset the clock (and timer).
your area do not carry time signals, set the clock
manually.
• Make sure the TV is set to the channel for the VCR. If
you are using a monitor, set it to video input.
• Adjust the tracking with the TRACKING +/– buttons.
• The video heads are dirty (see the last page of
"Troubleshooting"). Clean the video heads using the Sony
T-25CLD, T-25CLDR, or T-25CLW video head cleaning
cassette. If these cleaning cassettes are not available in
your area, have the heads cleaned at your nearest Sony
dealer (a standard service fee will be charged). Do not use
a commercially available liquid type cleaning cassette
other than Sony's, as it may damage the video heads.
• The video heads may have to be replaced. Consult your
local Sony dealer for more information.
• Adjust the vertical hold control on the TV or monitor.
• The tape is defective.
• If you made A/V connections, check the audio cable
connection.
• Make sure the TV is set to the channel for the VCR. If
you are using a monitor, set it to video input.
• Select the correct source with the INPUT SELECT or CH
+/– buttons. Select a channel number when recording TV
programs; select "L1" or "L2" when recording from other
equipment.
• Adjust the TV antenna.
• The safety tab has been removed. To record on this tape,
cover the tab hole.
• Check that the safety tab has not been removed.
• Make sure the tape is not at its end.
continued
103
Troubleshooting