Sony SLV-N80 Operating Instructions Manual page 32

3
PLAY
OK
4
PLAY
OK
5
PLAY
OK
6
MENU
7
Tip
• If you want to return to the previous menu, highlight RETURN and press OK.
Notes
• The clock cannot be set automatically if you don't receive a channel that carries a time signal
in your area. If so, set the clock manually (see page 36).
• If there are only a few channels in your area that carry time signals, setting the clock
automatically may take up to about 30 minutes. If nothing happens even after you wait about
30 minutes, set the clock manually.
• If you use Hookup 1 or 5, make sure you leave the cable box on.
• If the clock is not set, "ACS" will flash in the display window whenever the VCR is turned
off. During this time, the VCR will search for a time signal.
32
Setting the clock
Press M/m to highlight AUTO, then press
OK.
Press M/m to highlight FULL AUTO, then
press OK.
Press M/m to highlight YES, then press OK.
Press MENU to exit the menu.
To activate the Auto Clock Set function, turn off the VCR. "ACS" will flash
in the display window.
The VCR automatically sets the clock by searching for a channel that
carries a time signal and sets your time zone and Daylight Saving Time (if
applicable).
If your clock is set to the wrong time zone or Daylight Saving Time, you
can adjust these settings without turning off the Auto Clock Set feature
(page 33).
AUTO CLOCK SET
FULL AUTO YES
CLOCK SET CH
TIME ZONE
DAYLIGHT SAVING
RETURN
SELECT :
SET : OK
QUIT : MENU
AUTO CLOCK SET
FULL AUTO YES
CLOCK SET CH NO
TIME ZONE
DAYLIGHT SAVING
RETURN
SELECT :
SET : OK
QUIT : MENU