Sony SLV-N80 Operating Instructions Manual page 43

To check the cable box control setting
1
Press CH +/– on the remote commander. Does the channel indicator on the cable
box or digital satellite receiver change? (Point the remote commander at the
VCR, not at the cable box or digital satellite receiver.)
2
Press all 10 number buttons (0 to 9) on the remote commander. Does the channel
indicator on the cable box or digital satellite receiver change?
If the answer to both 1 and 2 is "yes," you have made the correct setting.
If you cannot get your VCR to control the cable box or digital satellite
receiver
• Check that the Cable Mouse is connected to the CABLE BOX CONTROL jack on
the VCR.
• Check the position of the Cable Mouse.
• Place the cable box or digital satellite receiver and VCR away from each other. Do
not place the cable box or digital satellite receiver on top of the VCR.
• Try the setup again making sure to use the correct control code. If the cable box
still does not respond, try the other codes that are listed.
If your cable box still does not operate with the Cable Mouse, contact your cable
company to see if they can provide you with a compatible cable box.
Note
• Make sure you turn off the VCR when you plug in or unplug the Cable Mouse. If you unplug
the Cable Mouse and plug it in again, turn on the VCR before you use the cable box or digital
satellite receiver control feature.
Setting up the cable box control (SLV-N80 only)
43