Kodak Miniloader 2000 Service Manual page 34

REPLACEMENTS
5
. Take off the DRIVE BELT.
6
. Take off the MOTOR MOUNTING SCREWS.
7
. Install the new MOTOR.
FUNCTION TEST.
1
. Check that the STEPPER MOTOR INTERFACE is running.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU press ENTER
ENTER SERVICE MODE MESSAGE is displayed press ENTER
UNIT DATA are displayed press ENTER
Select COMPONENT TEST press ENTER
Select INTERFACE/FILM MOT press ENTER
Select STEPPER MOTOR INTERFACE M13 press ENTER
Select ON/OFF
2
. Exit the SERVICE PROGRAM
Press BACKSPACE 3 times
Select LEAVE COMPONENT TEST press ENTER
Select QUIT ML2000 SERVICE MODE press ENTER
Select Quit the program press ENTER.
6/97
figure 2-20
2-24
SM 3477
KODAK AG, Stuttgart