Using the Stacker
Making Settings on the Control Panel
This section explains how to make output to the stacker using the main control
panel.
Important
❒ The following functions cannot be performed when delivering to the stacker:
2
• Reverse Ejection: Face Up/Down
• Staple
• Punch
• Fold
• Ring Binding
• Perfect Binding
❒ Output tray settings must to be specified in advance. For details about output
tray settings, see "Output Tray Settings".
A
Make sure that there is no paper on the tray from the last job. If there is pa-
per, remove it.
For details about how to remove paper, see "Removing Paper".
B
Specify the job settings.
C
Press [Sort / Stack].
D
To sort, enter the number of printed sets using the number keys. To stack,
enter the number of prints of one original using the number keys, and then
press [OK].
E
Press the {Start} key.
Reference
p.15 "Output Tray Settings"
p.22 "Removing Paper"
20