Timer Recording Radio Programs - Sony CMT-SE9 Operating Instructions Manual

Timer recording radio
programs
You can record a preset radio station from a
specified time.
To timer record, you must first preset the radio
station (see "Presetting radio stations" on
page 62) and set the clock (see "Setting the
clock" on page 12).
1
Tune in the preset radio station (see
"Listening to a preset station" on
page 63).
2
Press CLOCK/TIMER SET.
3
Press . or > repeatedly to select
"REC SET?", then press ENTER.
4
Press . or > repeatedly until the
timer number (e.g., "REC 1") you want
to set appears, then press ENTER.
5
Press . or > repeatedly until the
desired type of timer appears.
• ONCE?: The timer activates only once.
• DAILY?: The timer activates at the same
time every day.
• WEEKLY?: The timer activates at the
same time on the set day of every week.
6
Press ENTER.
When you select "ONCE?" or
"WEEKLY?" in step 5, the day of the week
indication flashes.
Proceed to step 9 when you select
"DAILY?" in step 5.
7
Press . or > repeatedly to set the
day of the week that the timer activates.
8
Press ENTER.
The hour indication flashes.
9
Set the time to start recording.
Press .
hour, then press ENTER.
The minute indication flashes.
Press .
minute, then press ENTER.
74 GB
or > repeatedly to set the
or > repeatedly to set the
10
Set the time to stop recording following
the same procedure as step 7 to 9.
11
Press . or > repeatedly to select
"MD" or "TAPE", then press ENTER.
12
When you record on an MD, press .
or > repeatedly to select the
recording mode (e.g., "LP2"), then
press ENTER.
The timer recording settings appear, then
the original display returns.
13
Load a recordable MD or tape.
14
Press ?/1 to turn off the system.
Other operations
To Do this
1
Check the setting Press CLOCK/TIMER
SELECT.
2
Press
repeatedly until "TIMER
SELECT?" appears, then
press ENTER.
3 Press m or M repeatedly
until the timer number (e.g.,
"REC 1") you want to check
appears, then press ENTER.
Change the setting Start over from step 1.
1
Active/cancel the Press
timer to display the timer number
(e.g., "REC 1") you want to
active/cancel in step 3 of
"Check the setting".
2
Press
repeatedly to select the timer
number (active the timer) or
" － " (cancel the timer), then
press ENTER.
If the timer is not set, " · "
appears.
. >
or
m M
or repeatedly
. >
or