Dividing Recorded Tracks; Divide Function - Sony CMT-SE9 Operating Instructions Manual

Dividing recorded tracks

— Divide Function

You can use this function to mark track numbers
after recording. You can also use this function
when recording from tapes or radio programs
and track numbers are not marked
automatically, and want to mark tracks. The
total number of tracks increases by one and all
the tracks following the divided ones are
renumbered.
Example: Dividing track 2 into two tracks
Track number
1 2
Original
A B
tracks
1 2
After
A B
DIVIDE
1
Press FUNCTION repeatedly to switch
the function to MD.
2
Press MENU/NO.
3
Press . or > repeatedly until
"Divide?" appears, then press ENTER.
Playback starts.
4
Press . or > repeatedly until the
desired track number to divide
appears.
5
While monitoring the sound, press
ENTER at the point to be divided.
"—Rehearsal—" appears and the portion to
be divided is played repeatedly.
3
C D
Divide track 2 into
track B and C
3 4
C D
6
Press ENTER again if the point to be
divided is correct.
"Complete!" appears for a few seconds and
the newly created track starts playing.
If the point to be divided is incorrect,
press . or >
divided, then press ENTER.
You can shift the point by 1/86 second
(1 frame) intervals.*
* You can shift the point by 2-frame intervals (in
Monaural mode and LP2 stereo mode) or by 4-
frame intervals (in LP4 stereo mode).
Note
If you divide a labelled track (page 52) into two tracks,
only the first track retains the track title.
Example:
1 2 3
B
A
1 2 3
A B
The new track is not labelled.
Tip
To shift the point by minute or second intervals in
step 6, press m or M repeatedly to flash minute,
second, or frame indication, then press . or >.
Minute
to find the point to be
4
C
4 5
C
Second
Frame
GB
59