Infrared (Ir) Repeater Hookups; Antenna Hookups - Sony STR-DA90ESG Operating Instructions Manual

Hooking Up the System

Infrared (IR) Repeater Hookups

The IR repeater emits infrared signals corresponding to
those emitted by the remote controls supplied with the
components. Connect the IR repeater if:
• You experience difficulty controlling a certain
component using the on-screen display control.
• Your installation configuration prevents the IR
repeater on the receiver's front panel from reaching
all of the components you need to control.
After connecting the IR repeater, set it above or below
the IR sensor on the component(s) to be controlled.
Each IR repeater can send infrared signals to one
component.
IR sensor
IR OUT
Note
Use the supplied adhesive tape to secure the IR repeater so
that its front faces the component to be controlled.
6
IR repeater
µ
Component
infrared
signals
IR repeater(s)

Antenna Hookups

You can receive radio broadcasts by connecting FM
and AM antennas.
FM wire antenna
(supplied)
ANTENNA
Extend the
FM wire
antenna
horizontally.
Connecting an outdoor antenna
We recommend that you connect an outdoor antenna
for better reception. Connect an optional FM outdoor
antenna for FM.
FM outdoor antenna
(not supplied)
ANTENNA
75-ohm 75
COAXIAL
coaxial cable
(not supplied)
Ground wire
(not supplied)
to ground
AM loop antenna
(supplied)
FM
75
COAXIAL
AM
Adjust the
direction.
FM
AM